P0934: Hydraulic Pressure Sensor Circuit Low Input — what it means, the affected system and what to check before replacing parts.
Meaning, symptoms, causes and checks
Hydraulic-pressure sensor: The electrical input is below its permitted range. This signal-level finding does not by itself establish a mechanical failure. An electrical sensor reading is not automatically an actual hydraulic pressure measurement. Confirm the sensing circuit before assuming pump failure or real pressure loss.
Affected system: Transmission hydraulic sensing and pressure unit
Symptoms
- Warning light may illuminate
- Related system function may be impaired
- Vehicle-specific symptoms vary
Possible causes
- Implausible sensor or switch signal, poor ground, connector corrosion, or wiring damage
- Related wiring, connector, power or ground fault
- Vehicle-specific mechanical or control issue
What to check
- Record stored and pending codes and freeze-frame data
- Compare the named sensor or switch signal with actual operating conditions; inspect the connector, reference supply, ground and harness.
- Confirm measured values against the vehicle service information
- Retest under the conditions that set the code
- Compare the named sensor or switch signal with actual operating conditions; inspect the connector, reference supply, ground and harness.
- Repair the verified cause and confirm the code does not return
Also written as: P0934-00, P093400, PO934 (some scan tools add the fault-type byte, e.g. -00).