P0826: Upshift/downshift switch input — circuit fault — what it means, the affected system and what to check before replacing parts.
Meaning, symptoms, causes and checks
The monitor for Upshift/downshift switch input reports a problem in the named circuit, without identifying a specific failed component. The driver request and the achieved gear are separate signals; this code alone does not confirm internal gearbox damage.
Affected system: Transmission selection and requests
Symptoms
- Warning light may illuminate
- Related system function may be impaired
- Vehicle-specific symptoms vary
Possible causes
- Transmission fluid, hydraulic, solenoid, connector, or control-circuit issue
- Related wiring, connector, power or ground fault
- Vehicle-specific mechanical or control issue
What to check
- Record stored and pending codes and freeze-frame data
- Compare commanded and actual transmission data, inspect fluid condition and level according to the vehicle procedure, then test the relevant circuit and solenoid.
- Confirm measured values against the vehicle service information
- Retest under the conditions that set the code
- Compare commanded and actual transmission data, inspect fluid condition and level according to the vehicle procedure, then test the relevant circuit and solenoid.
- Repair the verified cause and confirm the code does not return
Also written as: P0826-00, P082600, PO826 (some scan tools add the fault-type byte, e.g. -00).