P0801: Reverse-inhibit control — circuit fault — what it means, the affected system and what to check before replacing parts.
Meaning, symptoms, causes and checks
The monitor for Reverse-inhibit control reports a problem in the named circuit, without identifying a specific failed component. The interlock must not be bypassed to force starting or reverse engagement; use the vehicle-specific circuit information.
Affected system: Transmission selection and requests
Symptoms
- Warning light may illuminate
- Related system function may be impaired
- Vehicle-specific symptoms vary
Possible causes
- Implausible sensor or switch signal, poor ground, connector corrosion, or wiring damage
- Related wiring, connector, power or ground fault
- Vehicle-specific mechanical or control issue
What to check
- Record stored and pending codes and freeze-frame data
- Compare the named sensor or switch signal with actual operating conditions; inspect the connector, reference supply, ground and harness.
- Confirm measured values against the vehicle service information
- Retest under the conditions that set the code
- Compare the named sensor or switch signal with actual operating conditions; inspect the connector, reference supply, ground and harness.
- Repair the verified cause and confirm the code does not return
Also written as: P0801-00, P080100, PO801 (some scan tools add the fault-type byte, e.g. -00).