P0054 — Oxygen sensor heater resistance — bank 1, sensor 2

P0054 indicates incorrect heater resistance or electrical behavior for bank 1, sensor 2. Sensor 2 is usually after the first catalyst; some exhaust layouts also have sensor 3. The monitor may use heater current; the code does not specify a universal resistance in ohms. Supply wiring and heater control strategies differ between vehicles.

Affected system: Powertrain

Symptoms

• Engine warning lamp and a stored code.
• The vehicle may drive normally while emissions monitoring remains incomplete.

Possible causes

• Open or degraded heater element, or a sensor with the wrong specification.
• Additional connection resistance or inadequate supply.

What to check

• Confirm B1S2 in the engine diagram and save related codes and freeze-frame data before clearing anything.
• With the exhaust cold, inspect the B1S2 harness for melted insulation, rubbing, water in the connector and loose terminals.
• Measure the disconnected cold heater at the identified pins; compare resistance with the specified temperature and exact part specification.
• Check loaded supply and starting current; correct cold resistance alone does not establish that the heater operates properly.
• After correcting the confirmed fault, repeat the OEM monitor conditions and check for code recurrence, beyond merely extinguishing the lamp.

Also written as: P0054-00, P005400, PO054 (some scan tools add the fault-type byte, e.g. -00).